Yamaha ecu flash data cable kit install#
Yamaha ecu flash data cable kit driver#
Yamaha ecu flash data cable kit license#

Pull on the adapter to ensure proper installation. After the plastic clip is seated correctly, press on the metal portion of the adapter. It allows you to set a Launch RPM and other Parameters to assist with getting fast consistent launches from your bike, all controlled by the stock ECU. Launch Control is part of the our Race Tools Package.

Yamaha ecu flash data cable kit install#

Install the EFI adapter onto the outlet of the fuel pump by removing the plastic clip from the adapterĪnd installing it onto the outlet of the pump basket. 2016-2021 Yamaha FZ-10 / MT-10 Launch Control Key.

Use figure 6 as a reference to the damper housing orientation.

Tighten the lock nut to the damper housing.

Yamaha ecu flash data cable kit license#

Install OE injectors into the fuel rail (Apply some grease on all O-rings) Data-Link ECU Flashing Kit Includes:-FTdataLink ECU Interface USB Cable-Bike-side programming harness to permanently install on your bike-FT ECU License to allow unlimited flashes for a single ecu Note: Installation documents are found in the Document Center once logged in to customer account.

Thread on the damper housing to the swivel fitting until the threads bottom out, then back out one turn.

Install the -6 ORB plug into the bottom of the damper housing.

Reconnect the battery and prime the fuel system to check for leaks.

Zip-tie the fuel hose along the center console rail as shown in figure 9.

Connect the straight connector to the EFI adapter.

Use figure 9 as a reference for the hose routing. Connect the 90° fitting of the supplied -6 hose to the fuel rail towards the front of the car.Install the EFI adapter onto the outlet of the fuel pump by removing the plastic clip from the adapter and installing it onto the outlet of the pump basket.Connect injector connectors using the supplied electrical adapters.Tighten the lock nut to the pulsation damper housing.Install fuel rail and injectors onto throttle body ensuring to properly seat the bottom of the injector on the factory cushions (Take care to not over tighten bolts).Install ID injectors into the fuel rail (Apply some grease on all O-rings).Thread on the pulsation damper housing to the swivel fitting until the threads bottom out, then back out one turn.Install the -6 ORB plug into the bottom of the pulsation damper housing.Thread on the regulator housing to the swivel fitting until the threads bottom out, then back out one turn.Install -06 ORB to -04 AN fitting into the bottom of the regulator housing.Install the -06 ORB swivel fitting (non adjustable side) on the outlet of the rail towards the rear of the vehicle.Install the -06 ORB to -06 AN fitting on the inlet of the rail towards the front of the vehicle.

Make sure to set aside the lower factory seals because they will be reused.

Remove (2) M5 bolts to uninstall the fuel rail and injectors.

Disconnect injector electrical connectors.

Make sure to disconnect the electrical connector and all hoses.

Remove firewall panel located behind the seats.

Yamaha ecu flash data cable kit driver#

Remove the driver seat using the same steps as the passenger seat.

Remove the engine cover and all 4 side covers identified in figure 9.

Install Fuel Rail, Injectors and Regulator Use figure 5 as a reference for all connections.ģ.

Reinstall fuel pump assembly into the fuel tank.